BUYER GUIDE / CUSTOM APPAREL

Approve the measurements.
Then approve the sample.

A size label alone does not define the garment you want. Before bulk production, connect the size chart, measuring method, physical sample and written approval.

Prepared by MERIDIO · 20 November 2026 · About our sourcing business

What should buyers approve?

For custom T-shirts and hoodies, agree the measurement points for each ordered size, the units and method, acceptable variation at each point, the sample reference and who can approve production. Keep unresolved changes visible. A measurement photo is evidence of a reading; it is not a substitute for approving the whole specification.

Download the size approval worksheet ↓

1. Use one chart and one measuring method.

Identify the style, fabric reference, size range and chart revision. State whether a figure describes the finished garment or the intended wearer. Label centimetres and inches clearly. Define the start and end of each measurement with a sketch or marked photograph, including how the garment is laid out and whether it is stretched.

Illustrative example: a flat chest width of 52 cm is a different quantity from a chest circumference of 52 cm. Naming both fields simply “chest” invites confusion. The figure here explains the distinction; it is not a MERIDIO size recommendation.

Agree separate variation limits for each measurement point. Do not assume one tolerance is suitable for every seam, fabric or fit. QIMA’s inspection guidance similarly calls for size-specific measurement points and tolerances, and treats fit as a separate check.

2. Review fit and the relevant sizes.

A garment can match a measurement chart while the buyer dislikes its fit. Review the intended silhouette and movement on a suitable wearer or agreed form, alongside the numerical checks. State which sizes require physical samples and which size differences need further review. An approved medium does not by itself confirm every other size.

Record any agreed washing or conditioning procedure before comparing readings. Keep fabric, construction and artwork changes connected to the sample version. If a revision affects fit, decide whether another sample is needed before production.

3. Make the production approval specific.

Use a dated decision tied to the chart and sample identifiers. Name the approval owner, accepted changes and any work still on hold. “Looks good” in an isolated message is difficult to interpret later when several sample versions exist.

Example wording to adapt: “Style [ID], chart [revision], sample [reference], sizes [list]: approved for [defined production scope]. Outstanding items: [none/list]. Any change to the approved measurements or material requires written approval from [owner].” This is a planning example, not a signed customer approval.

Review the general sample approval template ↗

4. Connect production checks to that reference.

Before checking bulk goods, confirm which sizes and quantities will be measured, the current chart and method, and how findings will be reported. Record actual readings against the agreed requirements. When an issue appears, identify the affected size or lot, ask for a proposed correction and obtain the buyer’s decision before the next agreed milestone. A sample check is not a promise that every unit is defect-free.

5. If a concern appears after delivery.

Preserve the approved chart and sample history. Ask the customer for the affected styles, sizes and quantities, measurement photographs using the agreed method, and whether the concern is dimensional or about fit. Compare the evidence before assigning responsibility or proposing a remedy.

In one owner-confirmed MERIDIO project involving 1,450 custom T-shirts and hoodies, the customer raised a sizing concern after receiving the finished goods. MERIDIO coordinated factory compensation discussions and helped address the customer’s loss. That project outcome does not guarantee compensation in another order.

Read the anonymised post-delivery case ↗

Which support fits your order?

Already selected a factory? Discuss sample-version records, supplier follow-up and agreed quality checks through Supplier Management. If you still need a manufacturer, start with Full-Service Sourcing. Share the garment type, approximate quantity, destination and current sample stage first; confidential supplier files can follow through an agreed channel.

Existing factory support ↗ Supplier search and sourcing ↗ Discuss your apparel project ↗

Source and scope.

Technical reference: QIMA: garment quality inspection procedures, checked 20 November 2026. The worksheet and approval example are MERIDIO planning aids, not client records, a universal inspection standard or a guarantee of fit. Inspection scope and responsibilities must be agreed for the actual order.